I've been frustrated by my inability to get the Arc Captain TIG welder to respond to the remote current control input. I have a foot pedal and a torch with a current control switch and pot - the later came from Arc captain, supplied with the machine.
I've also been frustrated by the difficulty communicating with the Arc Captain "customer support"(?) team, who have often left me incommunicado for weeks at a time.
Finally this week I received some info from the "product department" which reads as the following:
The product department has replied to my enquiry: The response is as follows:
TIG200PACDC
1】Correct method for connecting the foot switch
1.1. First, connect the foot switch control cable to the 5-pin aviation connector on the front panel of the welding machine
1.2. Switch on the welding machine
1.3. Select the DC-TIG or AC-TIG welding mode via the control panel
1.4. Set the display to 200A; press the foot switch (gradually increasing pressure), and the current value displayed should rise accordingly
Note: 1. The maximum current controlled by the foot switch will not exceed the value set on the panel
2. The current value will only change whilst welding; it will remain static on the display when no welding is taking place.
3. For the TIG200PACDC US-spec model, the control cable must be connected before switching on the machine; furthermore, the user interface does not display a ‘foot switch connected’ indicator;
4. For the TIG200PACDC European specification model, press and hold the foot switch for 5 seconds after switching on the machine; when the ‘2T’ or ‘4T’ indicator light on the display begins to flash, this indicates a successful connection.
2】Troubleshooting Guide for Foot Switch Malfunctions
Troubleshoot in four areas: operating procedure, control cable, foot switch unit, and welding machine
- I don't need to set the machine to 200A (ie full blast) at all - I can set it to a more sane 50A or so.
- It's necessary to run this procedure every time you power up the machine if you want the remote current to be enabled, whether via the pedal or the torch.
- The foot pedal isn't set up correctly(!). The current varies from ~40A down to 25A and back up to ~50A. Sounds as if I've got the pot connections mixed up.
- With the original torch handle pot fitted (as in the photo), I can vary the current from close to zero to whatever the front panel setting is set to. This is what you'd hope for.
- That's a big relief. It looks as if there's nothing wrong with my welder, only the lack of instruction or physicness.
- I can now test out my TIG button circuit finally....

No comments:
Post a Comment