Sunday, 15 November 2026

Assembling, flashing and setting up the Glow pulse reader (meter reader)

Now that I've got a half decent looking enclosure and the photo detector boards have arrived, it's time to assemble everything, flash the ESP32 and get it set up with Home Assistant.

I repositioned the light dependent resistor (LDR - this one's not actually using a photo diode) so that peers down the little tunnel. It will be held in place with an M3 button headed screw.


The LEDs need current limiting resistors of differing values due to their different forward voltages.


Some heatshrink sleeving to protect the wiring, and interconnection wiring fitted.


Threading the M3 hole for the screw:


Everything in place now.


It powers up, so it appears I've not totally screwed up here:


The flashing process is pretty simple, as spelt out on the Glow project page. With these Chinesium ESP32-C3 Super Minis, you need to press the boot and reset buttons before the firmware can be flashed. Then log in to the ESP32 directly from your phone (at 192.168.4.1), give it your SSID and password for your wifi network and finally you can see it in Home Assistant. 

The configuration is pretty straightforward:

Finally, get Claude to add some cards showing instantaneous and cumulative usage.

There's clearly some heavy filtering going on here but the kettle went on about 18:10 or so and the oven went on around 18:45, before getting up to temperature and settling down to a steady state.




Not much to show yet but once it's been running for a day or so, we should have a better idea of how much electrical energy we are using and perhaps where it's going. "Today" didn't start until just after 18:00, so 2.527kWh is a small fraction of today's total consumption.

Job done - now let it grab some data.

No comments:

Post a Comment

Assembling, flashing and setting up the Glow pulse reader (meter reader)

Now that I've got a half decent looking enclosure and the photo detector boards have arrived, it's time to assemble everything, flas...